HP StorageWorks 6000-series Virtual Library System User Guide (AH809-96049, September 2010)

2. Press the power supply release lever (1), and then pull the power supply from the node.
To replace the component:
WARNING!
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to
the power supply until the power supply is installed.
1. Remove the protective cover from the connector pins on the power supply.
2. Slide the power supply into the bay until it clicks.
3. Use the strain relief clip to secure the power cord.
4. Connect the power cord to the power supply.
5. Be sure that the power supply LED is green.
6. Be sure that the front panel external health LED is green.
Component Replacement274