HP StorageWorks 6000-series Virtual Library System User Guide (AH809-96049, September 2010)

2. Install the two slide rails in the rack.
a. Locate the slide rail with the words REAR LEFT and align it with the rear of the left side of
the rack as you face the front of the rack.
b. Adjust the slide rail assemblies to the approximate rack depth.
c. From the outside rear of the rack, insert the screws of the slide rail rear bracket into the
appropriate holes in the rack and pull the rail forward until the rear bracket of the rail snaps
into place.
Figure 14 Attaching the rear bracket of the slide rail to the rack
.
d. From the outside front of the rack on the left rail, insert the screws of the slide rail front bracket
into the appropriate holes in the rack and push the rail back until the front bracket of the
rail snaps into place.
e. Repeat these steps with the right bracket on the right side of the rack.
Attach Rails to the VLS6600 Node (appliance)
To attach the rails to the appliance:
1. Align one of the rails with the left side of the node (as you face the front of the node) so that the
word “FRONT” on the rail is seen right-side-up and at the front of the node.
Figure 15 Attaching rails to the VLS6600 node
.
2. Align the holes in the rail with the round tabs on the side of the node.
3. Put the rail onto the node with the tabs extending into the holes on the side of the rail, then slide
the rail toward the front of the node until the tabs are locked into the rail.
HP StorageWorks 6000–series Virtual Library System User Guide 47