6.1 HP IBRIX X9000 Network Storage System Installation Guide (TA768-96058, June 2012)

tag with a FSN interface. For more information, see the HP IBRIX X9000 Network Storage
System Network Best Practices Guide.
Review the information on the Configuration Summary that appears next, select Commit, and
the wizard will set up the server.
7. Select a method to complete the installation:
• The eWizard. This wizard configures and registers your new servers in a few steps. This
method can be used only if the original X9320 cluster was configured with X9000
software 6.1 using the wizard. The cluster must use the unified network.
• ASCII text mode. This is a continuation of the menus you have been using. This method
must be used for all other expansions, as it allows the network on the new server to be
configured to match the existing cluster. See “Completing the installation in text mode”
(page 136).
Completing the installation with the eWizard
Exit the ASCII text wizard and complete the following steps:
1. Open the GUI, select Cluster Configuration from the Navigator, and then click Getting Started
from the Summary panel.
2. On the Getting Started Wizard menu, select File Servers. The wizard executes a new server
discovery and specifies the new servers as Not Defined in the Hostname column.
Completing the installation with the eWizard 135