6.1 HP IBRIX X9000 Network Storage System Installation Guide (TA768-96058, June 2012)

14. Enter the DNS and NTP server information used by the Onboard Administrator.
15. The wizard now configures the OA. This process takes up to 45 minutes to complete.
16. Next, the wizard verifies the VC configuration and creates a new user called hpspAdmin.
You may need to provide input for the following:
• The wizard attempts to log into the Virtual Connect manager using the Administrator
password you supplied earlier. If the attempt fails, you can retry the attempt or re-enter
the password. (Retry is helpful only if a timeout caused the VC password check to fail.)
When the wizard can log into the VC manager successfully, it verifies the VC firmware
and asks you to update it if necessary.
When the firmware is at the correct level, the wizard verifies that the VC is in a default
state.
17. The wizard configures the VC. The setup process first powers down blades 2–16, and then
powers down blade 1. On blade 1, the power remains off for approximately 3 minutes. Blade
1 then reboots twice.
Log into blade1 again when the Linux login prompt appears.
56 Installing X9730 systems