HP X5000 G2 Network Storage System Administrator Guide

8. Lift the release tab on the side or bottom rail (1, Figure 105 (page 101)), and then slide the
rail toward the front of the drive drawer to remove the rail (2).
NOTE: Repeat this step for all rails.
Figure 105 Removing the drive drawer rails
Replacing the drive drawer rails
1. Align the replacement rail with the tabs, and slide it toward the back of the drive drawer until
the rail locks into place (Figure 106 (page 101)).
Figure 106 Installing the drive drawer rails
2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive
drawer partially back into the system enclosure so that approximately two inches of the drawer
is still out of the enclosure (Figure 107 (page 102)).
CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect
the power coil assembly to prevent damaging the power coil assembly.
Removing and replacing the drive drawer rails (side or bottom) 101