HP X5000 G2 Network Storage System Administrator Guide

Replacing the enclosure rails
1. Align the replacement rail, and then attach it by sliding the rail toward the front of the enclosure
(Figure 116 (page 106)).
Figure 116 Installing the enclosure rails
2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive
drawer partially back into the system enclosure so that approximately two inches of the drawer
is still out of the enclosure (Figure 117 (page 106)).
CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect
the power coil assembly to prevent damaging the power coil assembly.
Figure 117 Partially installing the drive drawer
3. Pull the cable slightly out of the coil power plug and connect it to the midplane board
(Figure 118 (page 107)).
106 Removing and replacing hardware components