HP X5000 G2 Network Storage System Administrator Guide

4. Remove the server blade (Figure 130 (page 114)):
a. Push the button to release the handle (1).
b. Pull the handle toward you (2).
c. Remove the server blade (3).
Figure 130 Removing the server blade
5. Press the release button on the access panel and slide the access panel to the left to remove
it.
6. The original 1210m cache module is connected to a capacitor pack, so observe the cache
module LEDs:
• If the amber 1210m cache LED is solid, data transfer to the flash device on the cache is
in progress. Do not remove the 1210m cache until the amber LED is off, and then continue
with the next step.
• If the amber 1210m cache LED is not lit, proceed to the next step.
7. Open the ejector latches (1, Figure 131 (page 114)) on each side of the 1210m cache module
slot.
Typically, opening the ejector latches ejects the cache module automatically. If the module
does not eject automatically after you open the ejector latches, remove the cache module (2)
by grasping only the edges.
Figure 131 Removing the cache module
8. Remove the capacitor pack (2, Figure 132 (page 115)).
The 1210m cache module (1), and the 1210m controller card (3) are also shown.
114 Removing and replacing hardware components