HP X5000 G2 Network Storage System Administrator Guide

2. Complete the following (Figure 134 (page 116)):
a. Install the replacement cache module in the cache module slot (1).
b. Close the ejector latches on the cache module slot (2).
Figure 134 Replacing the cache module
3. Install the capacitor pack bracket and insert the capacitor pack on the chassis wall.
4. Install the access panel.
5. Install the server blade into the enclosure.
Removing and replacing the capacitor pack
Removing the capacitor pack
WARNING! Wear gloves or use care when removing the capacitor pack to avoid physical injury.
CAUTION: ESD can damage electronic components. Be sure you are properly grounded before
performing this procedure.
1. Back up all data.
2. Close all applications.
3. Power off the server blade.
4. Remove the server blade (Figure 135 (page 116)):
a. Push the button to release the handle (1).
b. Pull the handle toward you (2).
c. Remove the server blade (3).
Figure 135 Removing the server blade
5. Press the release button on the access panel and slide the access panel to the left to remove
it.
116 Removing and replacing hardware components