HP X5000 G2 Network Storage System Administrator Guide

6. The original capacitor pack is connected to a cache module, so observe the cache module
LEDs:
• If the amber cache LED is solid, data transfer to the flash device on the cache is in progress.
Do not remove the cache until the amber LED is off, and then continue with the next step.
• If the amber cache LED is not lit, proceed to the next step.
7. Open the ejector latches (1, Figure 136 (page 117)) on each side of the cache module slot.
Typically, opening the ejector latches ejects the cache module automatically. If the module
does not eject automatically after you open the ejector latches, remove the cache module (2)
by grasping only the edges.
Figure 136 Removing the cache module
8. Remove the cache module (1, Figure 137 (page 117)) from the controller card (3) and the
capacitor pack (2) from the server blade.
Figure 137 Removing the cache module and the capacitor pack
Removing and replacing the 1210m controller board components 117