HP X5000 G2 Network Storage System Administrator Guide

DISABLE NTP
Syntax
DISABLE NTP
Description
Disables the synchronizing of time and date with a remote server using the NTP protocol. Does
not clear any NTP servers that have been configured with SET NTP.
Restrictions
None
CLEAR NTP
Syntax
CLEAR NTP {PRIMARY | SECONDARY }
Description
Clears the Primary or Secondary NTP server IP address.
Restrictions
Clearing the Primary NTP address disables NTP.
SET NTP POLL
Syntax
SET NTP POLL <seconds>
Description
Sets the polling interval for NTP servers. The factory default polling interval is 720 seconds (12
minutes).
Restrictions
The polling range is 60 – 86400 seconds (1 minute to 1 day).
NOTE: EM 1.10 or later does not support this command.
SET NTP PRIMARY
Syntax
SET NTP PRIMARY <host>
Description
Sets the primary server used for synchronizing time/date using the Network Time Protocol (NTP).
<host> can be either an IPv4 address, an IPv6 address, or a DNS name.
Restrictions
• IPv4 addresses must be in the form ###.###.###.###, where each ### ranges from 0 to
255.
• IPv6 addresses must be formed without the network prefix length.
Time functions 137