HP X5000 G2 Network Storage System Administrator Guide

Removing the system enclosure from the rack
1. Extend the hard drive drawer (Figure 45 (page 67)):
a. Press upward on the release button on the hard drive drawer (1).
b. Pull the drawer handle down 90 degrees (2).
c. Extend the hard drive drawer (3).
Figure 45 Extending the hard drive drawer
2. Label the hard drives (Figure 46 (page 67)).
IMPORTANT: Use the drive labels provided with the replacement part when removing the
drives to ensure you replace the drives in the correct order.
Figure 46 Hard drive labeling
3. Remove all hard drives.
WARNING! Carefully check the drive labels provided with the replacement board, and then
install the hard drives in the same slots from which you removed them. If the drives are not
installed in the correct slots, the system might fail.
4. Push the hard drive drawer back into the system enclosure.
5. Label each server blade and then remove both server blades.
6. Label the cables and then unplug all cables from the back of the system enclosure.
Removing the system enclosure from the rack 67