HP X5000 G2 Network Storage System Administrator Guide

7. Unscrew the retaining screws from the bezel ears, and then remove the enclosure from the
rack.
WARNING! The system enclosure is heavy, even after removing the hard drives. Always
use at least two people to remove the system from the rack.
Inserting the system enclosure into the rack
1. Place the enclosure into the rack, and secure the enclosure by tightening the two retaining
screws.
WARNING! The system enclosure is heavy, even after removing the hard drives. Always
use at least two people to replace the system in the rack.
2. Replace both server blades in their original bays.
3. Extend the hard drive drawer (Figure 47 (page 68)):
a. Press upward on the release button on the hard drive drawer (1).
b. Pull the drawer handle down 90 degrees (2).
c. Extend the hard drive drawer (3).
Figure 47 Extending the hard drive drawer
4. Replace all hard drives.
IMPORTANT: Install the hard drives in the same slots from which you removed them or the
system might fail. Use the drive labels to ensure that you replace the drives in the correct order.
5. Push the hard drive drawer back into the system enclosure.
6. Plug in all cables at the back of the system enclosure, and ensure that all cables are returned
to their original locations.
7. Power on the system by pressing the power button ON.
8. Confirm that the system has resumed normal operations.
Removing and replacing the server interposer board
Removing the server interposer board
1. Verify the failed component as described in “Verifying component failure” (page 66).
2. Power off the system as described in “Powering the storage system off and on” (page 60).
3. Remove the enclosure from the rack as described in “Removing the system enclosure from the
rack” (page 67).
68 Removing and replacing hardware components