HP X5000 G2 Network Storage System Administrator Guide

Replacing the power supply
1. Insert the replacement power supply.
2. Plug the power cord into the power supply.
3. Verify that the replacement component is working properly by checking the associated LED
status.
4. Confirm that the system has resumed normal operations.
Removing and replacing the HP Ethernet I/O module
Removing the HP Ethernet I/O module
1. Verify the failed component as described in “Verifying component failure” (page 66).
2. Label the cables, and then unplug all cables from the HP Ethernet I/O module.
3. Press the module release mechanism to the right (1, Figure 64 (page 78)), and then remove
the failed module (2).
Figure 64 Removing the HP Ethernet I/O module
Replacing the HP Ethernet I/O module
1. Insert the replacement HP Ethernet I/O module (Figure 65 (page 78)).
Figure 65 Replacing the HP Ethernet I/O module
2. Plug in all cables to the replacement module to their original locations.
78 Removing and replacing hardware components