HP X5000 G2 Network Storage System Administrator Guide

7. Complete the following (Figure 67 (page 80)):
a. Remove the two screws from the bracket of the failed PCIe module (1).
b. Remove the bracket (2).
c. Remove the PCIe card from the failed module (3).
Figure 67 Removing the PCIe card
Replacing the PCIe module
1. Install the PCIe card in the replacement module (1, Figure 68 (page 80)), replace the bracket
(2), and then reinsert the two screws into the bracket of the replacement module (3).
Figure 68 Installing the PCIe card
2. Insert the replacement PCIe module into the system (1, Figure 69 (page 81)), and lock the
release lever (2).
NOTE: The PCIe module should be inserted with the lever in the open position.
80 Removing and replacing hardware components