HP X5000 G2 Network Storage System Administrator Guide

Figure 69 Installing the PCIe module
3. Plug in all cables to the PCIe module in their original locations.
4. Power on the server blade by pressing the power button ON.
5. Verify that the replacement component is working properly by checking the associated LED
status.
6. Confirm that the system has resumed normal operations.
Removing and replacing the EMU module
Removing the EMU module
1. Verify the failed component as described in “Verifying component failure” (page 66).
2. Unplug any cables from the EMU module.
3. Press the EMU module release lever to the right (1, Figure 70 (page 81)), and then remove
the EMU module (2).
Figure 70 Removing the EMU
Removing and replacing the EMU module 81