HP X5000 G2 Network Storage System Administrator Guide

3. Remove all eight screws from the front bezel (1, Figure 78 (page 86)), and then lift the front
bezel up and out to remove the front bezel (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
Figure 78 Removing the front bezel
Replacing the front bezel
1. Install the replacement front bezel with the handle at a 90 degree angle making sure the
bottom pins are aligned with the bottom holes (1, Figure 79 (page 86)), and replace the
screws into the front bezel (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
Figure 79 Replacing the front bezel
2. Push the drive drawer back into the system enclosure.
3. Power on the system by pressing the power button ON.
4. Verify that the replacement component is working properly by checking the associated LED
status.
5. Confirm that the system has resumed normal operations.
86 Removing and replacing hardware components