HP X5000 G2 Network Storage System Administrator Guide

Replacing the front bezel (full)
1. Install the replacement front bezel with the handle at a 90 degree angle, making sure the
bottom pins are aligned with the bottom holes (1, Figure 81 (page 88)), and replace the
screws in the front bezel (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
Figure 81 Replacing the front bezel
2. Close the drive handle.
3. Push the drive drawer back into the system enclosure.
4. Replace the enclosure as described in “Inserting the system enclosure into the rack” (page 68).
Removing and replacing the front LED display board in the rack (standard)
NOTE: If you are not able to access all of the screws due to the enclosure position in the rack,
use the full procedure instructions.
Removing the front LED display board in the rack
1. Verify the failed component as described in “Verifying component failure” (page 66).
2. Power off the system as described in “Powering the storage system off and on” (page 60).
3. Remove the front bezel as described in “Replacing the front bezel” (page 86).
88 Removing and replacing hardware components