HP X5000 G2 Network Storage System Administrator Guide

4. Pull the hard drive drawer handle down 90 degrees, and slide out the hard drive drawer.
5. Remove all eight screws from front bezel (1, Figure 84 (page 90)). Then, lift the front bezel
up and out to remove the front bezel (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
Figure 84 Removing the front bezel
6. Complete the following (Figure 85 (page 90)):
a. Disconnect the LED display board from the drive backplane by pinching the ends of the
LED display board cable together (1).
b. Remove the four screws from the LED display board (2).
c. Remove the LED display board from the drive drawer (3).
Figure 85 Removing the front LED display board
90 Removing and replacing hardware components