HP StorageWorks 1/8 G2 Tape Autoloader firmware release notes Firmware version 3.10 (AK377-96018, September 2010)

HP StorageWorks 1/8 G2 Tape

Autoloader firmware release notes

Firmware version 3.10

Part Number: AK377-96018

First edition: September 20, 2010

PAGE 1
HP StorageWorks 1/8 G2 Tape Autoloader firmware release notes Firmware version 3.
PAGE 3
Version: 3.10 Description This release includes updated firmware for the HP StorageWorks 1/8 G2 Tape Autoloader . The Autoloader firmware can be updated through any of the following methods: • Remote management interface (RMI). • Operator control panel (OCP) using a USB flash drive. • HP Library and Tape Tools (L&TT). Autoloader firmware version 3.10 Compatible robotics firmware version Update recommendation Supersedes 2.30e Recommended All previous versions of Autoloader firmware.
PAGE 4
• The cleaning tape barcode label is now recorded into the cartridge memory for LTO-4 and LTO5 drives. • Fixed a case where the drive status displayed as READY on the OCP and RMI while the drive was not connected. The drive status now displays OFFLINE when the drive status is not ready. Compatibility note When using firmware version 2.
PAGE 5
. On the Update Firmware tab, select the box next to each device for which you want to update firmware. If firmware is currently available for that device, it is shown in Firmware File in the File Selection section of the screen. 6. Click Start Update at the bottom of the screen to begin the update. Determining current version To find the version of firmware installed on the Autoloader from the RMI, see the Support: Firmware screen.
PAGE 6