HP StoreEver MSL4048 Tape Library Getting Started (AK380-96016, December 2012)

Slot numbering
NOTE: When the mailslot is enabled, the slots
in the lower-left magazine are numbered as
below. All other slots are renumbered.
Magazine release
When possible, release the magazines from the OCP
or RMI. If you must remove the magazines when the
library is not powered on, 1) insert a straightened
paperclip or small pin about 1.5 cm (0.6 inch) into
the magazine release hole on the back panel, while
2) another person removes the magazines from that
side.
IMPORTANT: Do not force the pin once you
encounter resistance. Doing so can damage the
library.
Mailslot
Enabling the mailslot in the left magazine allows you
to insert and remove tapes without removing the
magazine and without the need for the administrative
password. You can open the mailslot from the front
panel or with host software that supports this function.
The mailslot cannot be opened with the RMI.
When the mailslot is enabled, the mailslot uses the
front three slots of the lower left magazine and the
storage slots are renumbered.
TIP: To see the slot numbering for your library
in its current configuration, see the RMI Status
> Inventory screen.
Page 14