HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Controller Hardware Revision 2 Robot Replacement Instructions

11. The Replace Robot Status screen appears, showing the timer counting down.
Step 3: Removing the failed robot
To remove the failed robot:
1. Open the library access door corresponding to the failed robot.
2. Referring to Figure 7, move the robot’s yellow locking lever into the full unlocked position. You
need to pull down on the handle to disengage the lever, then move it all the way to the left. Make
sure it snaps into place after you move it.
3. Verify that the robot is unlocked by checking the Sensors Disengaged LED on the robot. The LED
should be on.
Step 3: Removing the failed robot 13