HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Controller Hardware Revision 2 Robot Replacement Instructions

Figure 7 Unlocking the robot
1. Move robot locking lever to unlocked position
2. Sensors Disengaged LED
4. Engage the robot kickstand (see Figure 6):
a. Lift the picker by the yellow handle just above the kickstand engagement tab.
b. Pull the locking lever back, then lower the picker slightly until the lever engages, and the
picker is held in place by the kickstand.
c. Let go of the picker handle.
5. Open the power rail collector door by loosening two thumbscrews; see Figure 8.
14 Step 3: Removing the failed robot