HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Controller Hardware Revision 2 Robot Replacement Instructions

Figure 8 Closing and opening the collector door
1. Tighten these thumbscrews to close door. Loosen thumbscrews to open door.
6. Place your hands in the proper positions on the robot so that when you remove the robot, you
will not hit your hands on library components. (One hand holds the yellow handle, the other holds
the vertical rail in the lift area shown in Figure 1.)
7. Slide the robot toward the center of the library until it is no longer underneath the loader bracket.
Figure 9 shows the loader bracket at the top of the library.
8. Lift the robot up first, then toward you slightly so that it is off of the racks, but do not pull it out of
the library yet.
9. While still holding the robot up, position it underneath the loader bracket. Then set the robot down
gently on the floor of the library.
10. Tilt the robot so the top of the robot is out of the library, then lift the bottom of the robot out of the
library.
11. Place the failed robot on the floor horizontally with the yellow handle facing up.
Step 3: Removing the failed robot 15