HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Controller Hardware Revision 2 Robot Replacement Instructions

Figure 14 Positioning power rail load guides
1. Power rail load guides
14. Close the collector door, and tighten the two captive thumbscrews (see Figure 2). This pushes the
collectors into the power rails.
15. Referring to Figure 14 through Figure 16, verify that the collectors are in their correct position in
the power rails:
• On both left- and right-side robots, the bottom collector is always in the bottom position
(position 7).
• In left-side robots or single robot libraries, the three upper collectors are in the positions 4 to
6 on the power rail.
• In right-side robots, the three upper collectors are in the top three positions (positions 1 to 3)
on the power rail.
22 Step 4: Installing the new robot