HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Controller Hardware Revision 2 Robot Replacement Instructions

7. Referring to Figure 6, engage the robot kickstand:
a. Lift the picker by the yellow handle just above the kickstand engagement tab.
b. Pull the locking lever back, then lower the picker slightly until the lever engages, and the
picker is held in place by the kickstand.
c. Let go of the picker handle.
Figure 6 Engaging the kickstand
1. Raise handle to lift picker into position
2. Locking lever
8. For now, leave the robot lying on its side close to the module containing the failed robot.
Step 2: Preparing the library
Make sure there is enough space on the floor or on a table to lay the failed robot down horizontally
after you take it out of the library.
To prepare the library:
1. Close any robot-related events on the library.
2. From the local Library Management Console (LMC touch screen), make sure you are viewing the
physical library. Select View and then select the physical library.
3. Select Tools→Library→Access
The Library Access Wizard screen appears.
4. Click Next.
The Library Access Selection screen appears.
Step 2: Preparing the library 9