HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library HDEM Magazine Calibration Target Replacement Instructions

6. Repeat the above steps for any additional

magazines that need to be removed.

Install the new calibration target with

magazine

1. Insert the replacement magazine with calibration

target in the appropriate space, making sure the

hooking tabs align with the anchor slots and the

barcode label is at the top.

CAUTION: Calibration targets for the

HDEM must be installed in column 1,

sections 1, 5, and 9 on the tower.

1. Calibration targets

2. Using both hands, gently push the magazine

downwards until it snaps into place.

NOTE: Make sure that all four tabs are

full engaged and that the back of the

magazine is flush with the side of the

HDEM tower.

3. Using the above steps, reinstall any magazine(s)

that needed to be removed in order to access the

magazine needing replacement.

4. Replace any media that needed to be removed.

5. Close the front access door.

Prepare the library for use

1. On the operator panel, press the Robotics Enabled

button to enable the picker assembly.

2. Run the Configure and Calibrate teach test. See

HP StoreEver Enterprise Systems Library (ESL) G3

Tape Library User Guide, Teaching the Library

(Configuration and Calibration) section.

HP web sites

For additional information, see these HP web sites:

• http://www.hp.com

• http://www.hp.com/go/storage

• http://www.hp.com/service_locator

• http://www.hp.com/support/manuals

Page 2