HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library I/O Management Unit Cooling Assembly Replacement Instructions

1. Slot 1 (empty)
2. Slot 2 (Control Management Blade)
3. Slot 3 (empty)
4. Slot 4 (empty)
5. Slot 5 (empty)
6. Slot 6 (empty)
7. Slot 7 (EEB for lower drive bay)
8. Slot 8 (EEB for upper drive bay)
9. Slot 9 (I/O management unit cooling assembly)
4. Loosen the thumbscrew securing the cooling
assembly to the I/O management unit.
1. Latch handle
2. Thumbscrew
This releases the cooling assembly latch handle.
5. Pull the latch handle down and use it to slide the
cooling assembly out of the I/O management
unit.
Install the new cooling assembly
1. Slide the new cooling assembly all the way into
the I/O management unit.
2. Push the latch handle all the way up.
3. Tighten the thumbscrew securing the cooling
assembly to the I/O management unit.
Prepare the library for use
1. Detach the ESD strap and close the service door.
2. Clear the event logged by the library when the
cooling assembly was removed.
HP web sites
For additional information, see these HP web sites:
• http://www.hp.com
• http://www.hp.com/go/storage
• http://www.hp.com/service_locator
• http://www.hp.com/support/manuals
Page 2