HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Library Motor Drive Card Replacement Instructions (QN998-96093, May 2013)

Prepare the library for use
1. On the power distribution unit, set the circuit
breaker switch to the up (I) position.
2. Detach the ESD strap and close the service access
door.
3. Press the Power button on the indicator panel.
The library begins to boot up. A library with only
a few drives usually will be fully powered on and
ready for use within 10 minutes. However, if a
library is large with a high number of drives, it
can take more than an hour for the library to fully
power on, complete the discovery process, and
become ready for use. During the power on
process, the Robotics Enabled indicator flashes.
When the library is fully powered on and ready
to receive commands, the Robotics Enabled
indicator turns solid green.
HP web sites
For additional information, see these HP web sites:
• http://www.hp.com
• http://www.hp.com/go/storage
• http://www.hp.com/service_locator
• http://www.hp.com/support/manuals
Page 3