HP StoreEver Tape Libraries Failover User Guide (5697-3323, June 2014)

Table Of Contents
The bottom pane shows failover session information that has been requested for the selected device.
Actions
There are several actions that can be performed by the diagnostic application.
Display worldwide port and node names (WWNs).
Refresh failover drivers’ state information held by the diagnostic application.
Request current failover information from tape and changer devices.
Clear reservations on changer devices which had been set by hosts that are now offline.
Display worldwide port and node names (WWNs)
Port and node worldwide names are only shown in the Devices and Paths panes when the Show
WWN menu item is selected, as shown below. Display of worldwide names is optional because
some host bus adapters can take up to thirty seconds to respond to a request for a WWN. When
there are many devices, this can lead to long delays in refreshing the screen.
Figure 20 Show WWN menu item
Refresh
The information in the Cached Driver Data pane can be refreshed by selecting ActionsRefresh
Cached Driver Data (F5).
Device information
The ActionsReport Device menu has three sub-menu items (see Figure 21 (page 56)) which report
information on the drive or media changer selected in the Devices Information pane. The data is
displayed in the Devices Information pane.
Figure 21 Report Device menu item
56 Troubleshooting failover operation