HP StorageWorks Ultrium Full-Height SCSI Tape Drives User Guide (EH853-90905, August 2007)

Figure 4 Re

moving c over from P roLiant ML370 server

1. Release catch

2. Push cover back and lift off

4. Remov e the ﬁller panel from a spare 5¼-inch b ay of your server, as described in your server’s

documentation. With some servers, such as the HP AlphaServer ES40, you must also remove the

half-height device divider.

5. You are now ready to install your tape drive.

Attach m

ounting hardware

If your s

erver requires special rails or other hardware to install the tape drive, mount them on the tape

drive now.

If your server does not require special mounting hardware, proceed to Install drive now.

CAUTION

The Ultr

ium half-height drive only allows 3 mm of the engagement of the screw into the drive. If you

remove

an existing drive, do not assume the screws that you remove are the correct length for your new

Ultrium d rive. Always use the screws supplied with your Ultrium drive.

HP ProLiant ser vers

NOTE:

If mounting hardware is supplied with your tape drive, it may not be exactly the same as shown in

the illustrations.

Different models of server require different mounting metho d s. The server may also incorporate a locking

mechanism to hold the tape drive in place. See Secure the drive.

Ultrium full-height SCSI Tape D rives