HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

/>set interface beacon
The following interfaces have beacon functionality:
You may enter 'q' at any time to quit.
Change beacon on interface 2 ? Enter 'y' or 'n' (default: n):y
Enable this beacon? Enter 'y' for on, 'n' for off (default: n):y
You may enter 'q' at any time to quit.
Change beacon on interface 3 ? Enter 'y' or 'n' (default: n):n
You may enter 'q' at any time to quit.
Change beacon on interface 4 ? Enter 'y' or 'n' (default: n):n
See Also show interface beacon
set interface clearwwnmismatch
Description Clears the World Wide Name (WWN) mismatch on an interface controller.
All WWN information shown is for the node name/ID. For more information,
see Managing the interface controllers (page 42).
Syntax set interface clearwwnmismatch interface_num
Availability All users and modes
Operands Specify the number of the interface controller.interface_num
Examples To clear the WWN mismatch on interface controller 1:
/>set interface clearwwnmismatch 1
See also set mgmt wwnstate
show interface wwninfo
set interface hostport alpa
Description Sets the ALPA for an interface port when the addressing mode of that port is
set to hard addressing. If the interface port mode is not set to hard addressing,
the ALPA is saved and used when the addressing mode is changed to hard
addressing.
Syntax set interface hostport alpa interface_num port_num address
Availability All users and manual mode only
Operands Specify the number of the interface. The ALPA may be
changed for all interfaces by specifying all for this
operand. This operand is required.
interface_num
port_num Specify the number of the port. The ALPA may be
changed for all ports by specifying all for this operand.
This operand is required.
address Specify the ALPA for the interface port. The ALPA may
be either in hex notation or base 10. The hex notation
must include the leading 0x, and letter digits may be in
upper or lower case. For example, to set the ALPA to
31, this operand could be either 0x1F or 0x1f in hex
notation or 31 in base 10. This operand is required.
Examples To set the ALPA on port 1 of interface 1 to 15:
/>set interface hostport alpa 1 1 15
Committing configuration...done
See also show interface hostport alpa
ALPA matrix
set interface clearwwnmismatch 207