HP StoreEver MSL6480 Tape Library Chassis Fan Assembly Replacement (QU625-96306, June 2013)

Installing the new chassis fan assembly
1. Align the tabs on the library with the slots at the
top of the chassis fan assembly.
2. Push in the chassis fan assembly until it is flush
with the back panel of the library.
3. Tighten the blue captive thumbscrews with your
fingers to secure it to the library.
2
1
Verifying the chassis fan assembly
installation
1. Verify that the new chassis fan assembly is
installed properly by checking the OCP or RMI;
the event that indicated the chassis fan assembly
was faulty should be cleared.
2. If the UID LEDs are still illuminated, deactivate
them using the OCP or RMI.
Getting help
• HP Product information: www.hp.com/products/
tapestorage
• HP technical support and phone numbers:
www.hp.com/support
• HP Library & Tape Tools (L&TT) diagnostic
software: www.hp.com/support/tapetools
Regulatory information
For important safety, environmental, and regulatory
information, see Safety and Compliance Information
for Server, Storage, Power, Networking, and Rack
Products, available at http://www.hp.com/support/
Safety-Compliance-EnterpriseProducts.
Documentation feedback
Send any errors, suggestions, or comments to
Documentation Feedback ([e-mail]).
Page 2