HP StorageWorks Fabric OS 6.3.3d Release Notes (5697-0493, May 2010 - includes all 6.3.0x versions)

Fixed in Fabric OS 6.3.0
FMS mode should be blocked when a logical switch is in 10 bit ad-
dressing.
Fixed in Fabric OS 6.3.0
TI Zone activation failed when pushing from DCFM to fabric with 6.2.0
and 6.1.2.
Fixed in Fabric OS 6.3.0
The drive is taken offline after container is failed back.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Issue hafailover or hareboot.
If configdownload is performed via DCFM, switch authentication
failure may occur.
Fixed in Fabric OS 6.3.0
Add FIP version 0 handling.
Fixed in Fabric OS 6.3.0
Address configdownload problems.
Fixed in Fabric OS 6.3.0
Due to race condition, daemons may panic during FID deletion and
creating without significant time delay in between.
Fixed in Fabric OS 6.3.0
Cold-failover within Port group for F_Port did not happen on Access
Gateway (AG).
Fixed in Fabric OS 6.3.0
Supportsave may show parity errors on disabled ports.
Fixed in Fabric OS 6.3.0
Switch Admin: Merge status dialog should display the status and
timestamp of last merge for FCoE Login.
Fixed in Fabric OS 6.3.0
Switch panic in kernel while access an iu that has already timed out
and freed.
Fixed in Fabric OS 6.3.0
Hosts on 4 Gb SAN switch for HP c-Class BladeSystem in Access
Gateway-mode lost their targets when failover happened from 1 trunk
group (with primary ports) to another trunk group (with shared area
ports) on 8 Gb 48 port blade of DC SAN Director.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Use the CLI interface.
WebTools shows no SFP details for CEE interfaces.
Fixed in Fabric OS 6.3.0
On Enabling LLDP status and assigning FCoE priority bits globally, is
not getting reflected in Port Admin window.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Do clean-up before downloading a
new CEE configuration: 1. In cmsh,
run "write erase" to clear
startup-config. 2. Reboot switch by
running "reboot" on FOS prompt. 3.
In cmsh, use "copy" command to
copy backup configuration into
running-config.
Confusing error message when copying a source configuration from
a remote server.
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Enable and disable port auto disable
for ports one at a time.
Defect ID: DEFECT000247893 Summary: Port Auto Disable - Ports
outside of given range are being enabled.
HP StorageWorks Fabric OS 6.3.0d Release Notes 55