Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 9-17
Publication Number: 53-1000242-01
EM-1061
9
EM-1061
Message
Probable
Cause
A blade in the system is not supported by the release on the standby CP.
Recommended
Action
Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken,
this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will
remain out of synchronization.
Severity WAR NIN G
EM-1062
Message
Probable
Cause
Too many blades of a particular type are in the system.
Recommended
Action
Please remove the faulted blade.
Severity CRITICAL
EM-1063
Message
Probable
Cause
Too many blades of a set of particular types are in the system.
Recommended
Action
Please remove the faulted blade.
<timestamp>, [EM-1061], <sequence-number>,, WARNING, <system-name>,
Synchronization halted. Remove all blades of type <Blade Type Id> or
upgrade your standby CP, then reboot or run haSyncStart.
<timestamp>, [EM-1062], <sequence-number>,, CRITICAL, <system-
name>, Blade in slot <Slot Id> faulted as it exceeds the maximum
support limit of <Limit> blades with Blade ID <Blade Type Id> in the
chassis.
<timestamp>, [EM-1063], <sequence-number>,, CRITICAL, <system-
name>, Blade in slot <Slot Id> faulted because it exceeds the
maximum support limit of <Limit> blades with Blade IDs <Applicable
blade Type IDs> in the chassis.