Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

11-4 Fabric OS Message Reference
Publication Number: 53-1000242-01
FABR-1008
11
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
FABR-1008
Message
Probable
Cause
Indicates that errors occurred during the request domain ID state; the information unit cannot be
allocated or sent. If this message occurs with FABR-1005, the problem is usually transitory. Otherwise,
this message is rare and usually indicates a problem with the Fabric OS. The error descriptions are as
follows:
• FAB RDI: cannot allocate IU
• FAB RDI: cannot send IU
Recommended
Action
No action is required if the message appears with the FABR_1005 message.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
FABR-1009
Message
Probable
Cause
Indicates that errors were reported during the exchange fabric parameter state; cannot allocate domain
list due to a faulty EFP type. This message is rare and usually indicates a problem with the Fabric OS.
Recommended
Action
The fabric daemon will discard the EFP. The system will recover through the EFP retrial process.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
FABR-1010
Message
<timestamp>, [FABR-1008], <sequence-number>,, WARNING, <system-
name>, <error description>
<timestamp>, [FABR-1009], <sequence-number>,, WARNING, <system-
name>, <error description>
<timestamp>, [FABR-1010], <sequence-number>,, WARNING, <system-
name>, <error description>