Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 16-1
Publication Number: 53-1000242-01
Chapter
16
FCPD System Messages
FCPD-1001
Message
Probable
Cause
Indicates that an FCP switch probed devices on a loop port, and the probing failed on the either the
L_Port, AL_PA address, or the F_Port. For the AL_PA, the valid range is 00 through FF. The error sting
can be either:
• L_Port port_number ALPA alpa_number
• F_Port port_number
Recommended
Action
This can happen when the firmware on the device controller on the specified port has a defect. Check
with the device vendor for a firmware upgrade containing a defect fix.
The SilkWorm 4100 does not support private loop devices.
Severity WAR NIN G
FCPD-1002
Message
Probable
Cause
Indicates that the response frame received on the specified port for a inquiry request contains an invalid
value in the routing control field.
Recommended
Action
This can happen only if the firmware on the device controller on the specified port has a defect. Check
with the device vendor for a firmware upgrade containing a defect fix.
Severity WAR NIN G
<timestamp>, [FCPD-1001], <sequence-number>,, WARNING, <system-
name>, Probing failed on <error string>
<timestamp>, [FCPD-1002], <sequence-number>,, WARNING, <system-
name>, port <port number>, bad R_CTL for fcp probing: 0x<R_CTL
value>