Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 18-17
Publication Number: 53-1000242-01
FCR-1057
18
Recommended
Action
No action is required if backbone to edge routing is not needed. Otherwise replace the switch with one
that supports backbone to edge routing.
Severity INFO
FCR-1057
Message
Probable
Cause
Indicates that the port, which is configured in long distance mode, has incompatible long distance
parameters.
Recommended
Action
Check the port configuration on both sides of the link using the portCfgShow command.
Investigate the other switch for more details. Run the errShow command on the other switch to view
the error log for additional messages.
Severity ERROR
FCR-1058
Message
Probable
Cause
Indicates that the specified port was isolated after segmentation, which was caused by mismatched
configuration parameters.
Recommended
Action
Please check the switches on both ends of the link for a possible mismatch in switch or port
configuration parameters such as 'Operating Mode', EDTOV, or RATOV.
Run the portCfgExport command to modify the appropriate parameters on the local switch.
Run the appropriate configuration command to modify the switch or port parameters on the remote
switch.
Severity WAR NIN G
FCR-1059
Message
<timestamp>, [FCR-1057], <sequence-number>,, ERROR, <system-name>,
EX port(<port number>) incompatible long distance parameters on
link.
<timestamp>, [FCR-1058], <sequence-number>,, WARNING, <system-
name>, Port <port number> isolated due to mismatched configuration
parameter; <segmentation reason>.
<timestamp>, [FCR-1059], <sequence-number>,, INFO, <system-name>,
EX port <port number> was disabled due to an authentication failure.