Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

19-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
FICU-1003
19
FICU-1003
Message
Probable
Cause
Indicates that the FICON-CUP license is not installed on the switch.
Recommended
Action
Run the licenseShow command to check the installed licenses on the switch. The switch cannot be
managed using FICON-CUP commands until the FICON-CUP license is installed. Contact your switch
supplier for a FICON-CUP license. Run the licenseAdd command to add the license to your switch.
Severity WAR NIN G
FICU-1004
Message
Probable
Cause
Indicates that a PID format conflict was encountered. The core PID format is required for FICON-CUP.
The pid_format variable displays the PID format currently running on the fabric, and is one of the
following:
• 0 is VC-encoded PID format
• 1 is core PID format
• 2 is extended-edge PID format
FMS mode displays whether FICON Management Server mode is enabled; a 0 means this mode is
enabled and a 1 means this mode is disabled.
Recommended
Action
For FICON Management Server mode (fmsMode) to be enabled, the core PID format must be used in
the fabric. Change the PID format to core PID using the configure command and reenable fmsmode
using the ficoCupSset command. Refer to the Fabric OS Administrator’s Guide for information on core
PID mode and the Fabric OS Command Reference for information on the configure command and
ficonCupSet command.
Severity WAR NIN G
<timestamp>, [FICU-1003], <sequence-number>,, WARNING, <system-
name>, <function name>: <message> FICON-CUP License Not Installed
(<error>)
<timestamp>, [FICU-1004], <sequence-number>,, WARNING, <system-
name>, <function name>: Failed to set FMS mode: conflicting PID
Format:<pid_format>, FMS Mode:<mode>