Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

22-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
FSPF-1005
22
Probable
Cause
Indicates that the specified remote domain ID is out of range.
Recommended
Action
No action is required; the frame is discarded.
Severity ERROR
FSPF-1005
Message
Probable
Cause
Indicates that an incorrect section ID was reported from the specified input port. The section ID is used
to identify a set of switches that share an identical topology database. The section ID is implemented
inside the protocol. The error message itself will indicate the mismatched section ID. It should be set to
0 for a nonhierarchical fabric. SilkWorm switches support only section ID 0.
Recommended
Action
Use a frame analyzer to verify that the reported section ID is 0. Any connected (other manufacturer)
switch with a section ID other than 0 is incompatible in a fabric of SilkWorm switches. Disconnect the
offending switch.
Severity ERROR
FSPF-1006
Message
Probable
Cause
Indicates that the FSPF version is not supported on the specified input port.
Recommended
Action
Update the FSPF version by running the firmwareDownload command to update the firmware to the
latest version. All current versions of the Fabric OS support FSPF version 2, which is the correct
version.
Severity ERROR
<timestamp>, [FSPF-1005], <sequence-number>,, ERROR, <system-name>,
Wrong Section Id <section number>, should be <section number>,
input port = <port number>
<timestamp>, [FSPF-1006], <sequence-number>,, ERROR, <system-name>,
FSPF Version <FSFP version> not supported, input port = <port
number>