Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 25-37
Publication Number: 53-1000242-01
FW-1219
25
Severity WAR NIN G
FW-1219
Message
Probable
Cause
Indicates that the number of CRC errors has changed from a value outside of the acceptable range to a
value within the acceptable range. This indicates that errors have been detected in the FC frame. Invalid
CRC messages occur when the number of CRC errors in Fibre Channel frames for specific source ID
(S_ID) and destination ID (D_ID) pairs change. These messages might also be caused by dirty
equipment, temperature fluctuations, and aging equipment. You should set your high boundaries to five-
or six-digit figures, as only large numbers of messages indicate a problem in this area.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity INFO
FW-1240
Message
Probable
Cause
Indicates that the number of EE CRC errors has changed. Invalid CRC messages occur when the
number of CRC errors in Fibre Channel frames for specific source ID (S_ID) and destination ID (D_ID)
pairs change. These messages might also be caused by dirty equipment, temperature fluctuations, and
aging equipment.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity INFO
FW-1241
Message
<timestamp>, [FW-1219], <sequence-number>,, INFO, <system-name>,
<Label>, is between high and low boundaries(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1240], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
<timestamp>, [FW-1241], <sequence-number>,, INFO, <system-name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.