Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 25-75
Publication Number: 53-1000242-01
FW-1378
25
FW-1378
Message
Probable
Cause
Indicates that the number of illegal commands has risen above the high boundary. This counter tracks
how many times commands allowed only on the primary FCS switch have been executed on a non-
primary FCS switch. There are many commands that can be executed only on the primary FCS switch
as well as one security command that can be executed only on a backup FCS switch. The counter
increments every time someone issues one of these commands on a switch where it is not allowed.
Recommended
Action
Responses to security-class messages depend on user policies. Consult your security administrator for
response strategies and policies.
Severity WAR NIN G
FW-1379
Message
Probable
Cause
Indicates that the number of illegal commands has changed from a value outside of the acceptable range
to a value within the acceptable range. This counter tracks how many times commands allowed only on
the primary FCS switch have been executed on a non-primary FCS switch. There are many commands
that can be executed only on the primary FCS switch as well as one security command that can be
executed only on a backup FCS switch. The counter increments every time someone issues one of these
commands on a switch where it is not allowed.
Recommended
Action
No action is required.
Severity INFO
FW-1400
Message
Probable
Cause
Indicates that the flash usage percentage has changed. Flash increases and decreases slightly with
normal operation of the switch. Excessive permanent increases can lead to future problems.
<timestamp>, [FW-1378], <sequence-number>,, WARNING, <system-name>,
<Label>, is above high boundary(High=<High value>, Low=<Low
value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1379], <sequence-number>,, INFO, <system-name>,
<Label>, is between high and low boundaries(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1400], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.