Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

25-80 Fabric OS Message Reference
Publication Number: 53-1000242-01
FW-1433
25
Recommended
Action
Replace the faulty WWN card.
Severity WAR NIN G
FW-1433
Message
Probable
Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of faulty CPs
is greater than or equal to the policy set by the switchStatusPolicySet command. The CPs are non-
redundant.
If you power cycle a SilkWorm 24000 chassis in dual-domain configuration, and then reset the micro-
switch of the active CP before the heartbeat is up, this will cause both CPs to come up in a non-
redundant state.
Recommended
Action
Run the firmwareShow command to verify that both CPs have compatible firmware levels. Run the
firmwareDownload command to install the same level of firmware to both CPs. Replace any faulty
CPs.
If you reset the micro-switch (the latch on the CP blade) on the active CP before the heartbeat was up on
a power cycle, and the CPs came up non-redundant, then you should reboot the CPs again to clear the
problem.
Severity WAR NIN G
FW-1434
Message
Probable
Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of blade
failures is greater than or equal to the policy set by the switchStatusPolicySet command.
Recommended
Action
Replace the faulty blade.
Severity WAR NIN G
<timestamp>, [FW-1433], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor CP: CP non-redundant.
<timestamp>, [FW-1434], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Blade: <Number Bad> blade
failures.