Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

34-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
IPS-1004
34
Probable
Cause
Indicates that memory resources are low. This might be a transient problem.
Recommended
Action
If the message persists, check the memory usage on the switch, using the memShow command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
IPS-1004
Message
Probable
Cause
Indicates that configured Port Mode is different from intended use.
Recommended
Action
Change the port configuration (by deleting configured FCIP tunnels or iSCSI sessions) to return the port
mode to neutral before attempting to configure the port for a different mode or use.
Severity WAR NIN G
IPS-1005
Message
Probable
Cause
Indicates that tunnel setup failed due to authorization failure from the remote side. Reasons for such
failures could be a WWN Mismatch.
Recommended
Action
Change the tunnel configuration on one side of the tunnel to authorize remote side to setup tunnel.
Severity WAR NIN G
IPS-1006
Message
<timestamp>, [IPS-1004], <sequence-number>,, WARNING, <system-
name>, Port Config Mode Mismatch slot (<slot>) port(ge<port>):
current mode is (<current mode>)
<timestamp>, [IPS-1005], <sequence-number>,, WARNING, <system-
name>, Tunnel Authorization Failure for slot (<slot>)
port(ge<port>) tunnel ID(<tunnel number>) reason (<reason>)
<timestamp>, [IPS-1006], <sequence-number>,, WARNING, <system-
name>, Tunnel Configuration Mismatch for slot (<slot>) port(<port>)
tunnel ID(<tunnel number>) reason (<reason>)