Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

58-6 Fabric OS Message Reference
Publication Number: 53-1000242-01
SEC-1029
58
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1029
Message
Probable
Cause
Indicates that a corruption occurred during the distribution of the security database. This can occur only
when the primary FCS distributes the security database to the other switches in the fabric, then local
validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1030
Message
Probable
Cause
Indicates that a corruption occurred during the distribution of the security database. This can occur only
when the primary FCS distributes the security database to the other switches in the fabric, then local
validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1031
Message
<timestamp>, [SEC-1029], <sequence-number>,, ERROR, <system-name>,
Invalid character in <policy name>.
<timestamp>, [SEC-1030], <sequence-number>, ERROR, <system-name>,
The length of the name invalid.
<timestamp>, [SEC-1031], <sequence-number>,, WARNING, <system-
name>, Current security policy DB cannot be supported by standby.
CPs will go out of sync.