Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-7
Publication Number: 53-1000242-01
SEC-1032
58
Probable
Cause
Indicates that the security database size is not supported by the standby CP.
Recommended
Action
Reduce the security database size by reducing the number of entries within each policy.
Severity WAR NIN G
SEC-1032
Message
Probable
Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1033
Message
Probable
Cause
Indicates that the member parameter in the secPolicyAdd command is invalid (such as the asterisk
symbol). Only valid switch identifiers, that is WWN, domain ID or switch name are supported for the
member parameter. The asterisk symbol can be used to add all switches only with the secPolicyCreate
command.
Recommended
Action
Run the secPolicyAdd command using a valid switch identifier (WWN, domain ID, or switch name) to
add specific switches to the SCC policy.
Refer to the Fabric OS Command Reference for more information on the secPolicyAdd and
secPolicyCreate commands.
Severity ERROR
<timestamp>, [SEC-1032], <sequence-number>,, ERROR, <system-name>,
Empty FCS list is not allowed.
<timestamp>, [SEC-1033], <sequence-number>,, ERROR, <system-name>,
Invalid character used in member parameter to add switch to SCC
policy; command terminated.