Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-19
Publication Number: 53-1000242-01
SEC-1077
58
SEC-1077
Message
Probable
Cause
Indicates that the policy could not be activated. Possible reasons that the policy could not be activate
include not enough memory or a busy switch.
Recommended
Action
Run the secFabricShow command to verify that all switches in the fabric are in the ready state. Retry
the command when all switches are ready.
Severity ERROR
SEC-1078
Message
Probable
Cause
Indicates that there are no new changes in the defined security policy database that can be aborted.
Recommended
Action
Verify that security event was planned. Verify if there were really any changes to the defined policy
database that can be aborted.
Severity ERROR
SEC-1079
Message
Probable
Cause
Indicates that the policy name entered in the secPolicyCreate|Activate|Add|Delete command was
invalid.
Recommended
Action
Run the command again using a valid policy name.
Severity ERROR
<timestamp>, [SEC-1077], <sequence-number>,, ERROR, <system-name>,
Failed to activate new policy set on all switches.
<timestamp>, [SEC-1078], <sequence-number>,, ERROR, <system-name>,
No new data to abort.
<timestamp>, [SEC-1079], <sequence-number>,, ERROR, <system-name>,
The policy name <policy name> is invalid.