Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-25
Publication Number: 53-1000242-01
SEC-1095
58
SEC-1095
Message
Probable
Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1096
Message
Probable
Cause
Indicates that a policy cannot be removed because deleting it would result in invalid security policy
configuration.
Recommended
Action
Verify the security policy configuration requirements and remove any policies that require the policy
you want to remove first.
Severity ERROR
SEC-1097
Message
Probable
Cause
Indicates that the specified policy could not be found.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
<timestamp>, [SEC-1095], <sequence-number>,, ERROR, <system-name>,
Deleting FCS policy is not allowed.
<timestamp>, [SEC-1096], <sequence-number>,, ERROR, <system-name>,
Failed to delete <policy name> because <reason text>
<timestamp>, [SEC-1097], <sequence-number>,, ERROR, <system-name>,
Cannot find <active or defined> policy set.