Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-29
Publication Number: 53-1000242-01
SEC-1108
58
SEC-1108
Message
Probable
Cause
Indicates that a version reset operation failed either because the switch could not get all the required
resources to perform the operation or because it failed to send the message to all switches in the fabric.
Recommended
Action
Verify that the security event was planned. If the security event was planned, run the secFabricShow
command to verify that all switches in the fabric are in the ready state. When all switches are in the
ready state, retry the operation.
Severity ERROR
SEC-1110
Message
Probable
Cause
Indicates that a security policy download is attempted with a defined policy that does not have the FCS
policy as the first policy. The FCS policy is required to be the first policy in the defined security
database.
Recommended
Action
Download a correct configuration with the FCS policy as the first policy in the defined security
database.
Severity ERROR
SEC-1111
Message
Probable
Cause
Indicates that the defined and active FCS policy list failed to have at least one member in common.
Recommended
Action
A new FCS policy list must have at least one member in common with the previous FCS policy.
Severity ERROR
<timestamp>, [SEC-1108], <sequence-number>,, ERROR, <system-name>,
Fail to reset stamp on all switches.
<timestamp>, [SEC-1110], <sequence-number>,, ERROR, <system-name>,
FCS list must be the first entry in the [Defined Security policies]
section. Fail to download defined database.
<timestamp>, [SEC-1111], <sequence-number>,, ERROR, <system-name>,
New defined FCS list must have at least one member in common with
current active FCS list. Fail to download defined database.