Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

58-30 Fabric OS Message Reference
Publication Number: 53-1000242-01
SEC-1112
58
SEC-1112
Message
Probable
Cause
Indicates that either a security policy download is attempted with an active policy that does not have the
FCS policy as the first policy or the FCS policy is not same as the current FCS policy on the switch.
Recommended
Action
Make sure that the new FCS policy is the same as the current FCS policy on the switch.
Severity ERROR
SEC-1115
Message
Probable
Cause
Indicates that during an attempted secFcsFailover, no primary FCS is present in the fabric.
Recommended
Action
Run the secFabricShow command to verify that all switches in fabric are in the ready state. When all
switches are in the ready state, retry the operation.
Severity ERROR
SEC-1116
Message
Probable
Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
<timestamp>, [SEC-1112], <sequence-number>,, ERROR, <system-name>,
FCS list must be the first entry in the Active Security policies,
and the same as the current active FCS list in the switch.
<timestamp>, [SEC-1115], <sequence-number>,, ERROR, <system-name>,
No primary FCS to failover.
<timestamp>, [SEC-1116], <sequence-number>,, ERROR, <system-name>,
Fail to commit failover.