Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

58-38 Fabric OS Message Reference
Publication Number: 53-1000242-01
SEC-1156
58
Recommended
Action
Reduce the size of the specified policy database.
Severity INFO
SEC-1156
Message
Probable
Cause
Indicates that the security daemon is busy. The status values can be either defined, active, or both. A
negative value means that a policy set was failed by the daemon.
Recommended
Action
For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands might
take a few minutes to propagate throughout the fabric. Make sure to wait a few minutes between
executing commands so that your commands do not overlap in the fabric.
Severity INFO
SEC-1157
Message
Probable
Cause
Indicates that the provisioning resources for a security policy failed due to low memory or internal error.
The status values can be either defined, active, or both. A negative value means that a policy set was
failed by the daemon.
Recommended
Action
Retry the failed command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
SEC-1158
Message
Probable
Cause
Indicates that the specified name is invalid. The name can be a policy name or a switch name.
<timestamp>, [SEC-1156], <sequence-number>,, INFO, <system-name>,
Change failed: <Reason> <defined status> <active status>.
<timestamp>, [SEC-1157], <sequence-number>,, INFO, <system-name>,
PID Change failed: <Reason> <defined status> <active status>.
<timestamp>, [SEC-1158], <sequence-number>,, INFO, <system-name>,
Invalid name <Policy or Switch name>.